*For each module given from the required components, the serial number in the next set of pages will be denoted as “SN”. The top display will say “DISABLED” in all caps to notify components being enforced. If the components reveal themselves in any combination, treat it as if these are required to solve the module. †A config exists to enforce specific components on The Modkit. To avoid confusion, zeros in this manual are represented by the character Ø. Include a component if any of the characters in the corresponding table cell are in the serial number. If multiple are tied (including the case where the bomb has no ports), use the leftmost tied column. Refer to the table below to decide what components to include.† Use the column corresponding to the most common port type on the bomb. If no component meets its condition to be in the module, press the “❖” button to disarm the module.Use the arrow buttons near the top display to cycle between the possible module components and press the “◆” button to toggle the corresponding component.Interacting with module components when the current component selection is not the correct one will cause a strike.In order to disarm the module, choose the right components for it and then solve it using the corresponding instructions in the pages below.The module consists of a display with module components, a “❖” button, a “◆” button, multiple smaller buttons and several containers for a wire panel, a symbol keypad, an alphanumeric keypad, a set of LEDs and a set of arrow buttons.See Appendix C for port identification reference. See Appendix B for battery identification reference. See Appendix A for indicator identification reference.
0 kommentar(er)
